$192.00 – $255.00
This item is out of stock.
Already 3 persons shown interest.
Kart Xact Fit Precision Barrel
Match Quality Barrel Installation Using Only Hand Tools
Install a quality Kart Xact Fit precision barrel using just four small hand tools. The fitting required is to adjust lockup with the two raised pads located on either side of the rear locking groove, cut the barrel hood to correct length and fit the bushing to the slide. A national match bushing is pre-fit to the barrel; oversize O.D. for precise fitting to slide. Fully finished Bottom lugs with the correct length link installed to save hours of work.
SPECS: 4150 ordnance steel, in-the-white. Available in 5″ (12.7cm), 6″ (15.2cm), or Commander 4.25” (10.8cm) lengths. (N/R) Non-ramped. (W/N) Wilson/Nowlin ramp. (C/P) Clark/Para ramp. Ramped barrels require machining of frame if not already machined for a ramped barrel. Includes instructions.
Kart NM gunsmith fit barrels available here.
|Dimensions||7 × 2 × 2 in|
4.25 Commander, 5 Govt, 6"
9mm, 38Super, 40, 10mm, 45ACP
Ramped W/N, Ramped C/P, Non Ramped